Users Guide

Internet Group Management Protocol (IGMP)
Internet group management protocol (IGMP) is a Layer 3 multicast protocol that hosts use to join or leave a multicast group.
Multicast is premised on identifying many hosts by a single destination IP address; hosts represented by the same IP address are
a multicast group. Multicast routing protocols (such as protocol-independent multicast [PIM]) use the information in IGMP
messages to discover which groups are active and to populate the multicast routing table.
IGMP Implementation Information
• The Dell Networking OS supports IGMP versions 1, 2, and 3 based on RFCs 1112, 2236, and 3376, respectively.
• The system does not support IGMP version 3 and versions 1 or 2 on the same subnet.
• Dell Networking switches cannot serve as an IGMP host or an IGMP version 1 IGMP Querier.
• The system automatically enables IGMP on interfaces on which you enable a multicast routing protocol.
Topics:
• IGMP Protocol Overview
• Configure IGMP
• Viewing IGMP Enabled Interfaces
• Selecting an IGMP Version
• Viewing IGMP Groups
• Enabling IGMP Immediate-Leave
• IGMP Snooping
• Fast Convergence after MSTP Topology Changes
• Designating a Multicast Router Interface
IGMP Protocol Overview
IGMP has three versions. Version 3 obsoletes and is backwards-compatible with version 2; version 2 obsoletes version 1.
IGMP Version 2
IGMP version 2 improves on version 1 by specifying IGMP Leave messages, which allows hosts to notify routers that they no
longer care about traffic for a particular group.
Leave messages reduce the amount of time that the router takes to stop forwarding traffic for a group to a subnet (leave
latency) after the last host leaves the group. In version 1 hosts quietly leave groups, and the router waits for a query response
timer several times the value of the query interval to expire before it stops forwarding traffic.
To receive multicast traffic from a particular source, a host must join the multicast group to which the source is sending traffic.
A host that is a member of a group is called a receiver. A host may join many groups, and may join or leave any group at any
time. A host joins and leaves a multicast group by sending an IGMP message to its IGMP Querier. The querier is the router that
surveys a subnet for multicast receivers and processes survey responses to populate the multicast routing table.
21
Internet Group Management Protocol (IGMP) 399