Users Guide

To display the current configuration of the reserved VLAN, enter the show vlan command.
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P -
Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
* 1 Inactive
R 100 Active T Fo 0/44
R 300 Active T Fo 0/52
Configuring Remote Port Monitoring
Remote port monitoring requires a source session (monitored ports on different source switches), a reserved
tagged VLAN for transporting mirrored traffic (configured on source, intermediate, and destination switches),
and a destination session (destination ports connected to analyzers on destination switches).
To configure a remote-port monitoring session:
Step Command Description
1
configure terminal Enter global configuration mode.
2
monitor session id type rpm Specify a unique session ID number and RPM as the
session type, and enter Monitoring-Session
configuration mode.
3
source {interface | range}
destination interface direction {rx |
tx | both}
Enter a source port or a range of source port interfaces
to be monitored. Enter the destination port interface.
Specify ingress (rx), egress (tx), or both ingress and
egress traffic to be monitored.
7
no disable Enter the no disable command to activate the RPM
session.
Examples of Remote-Port Monitoring Configuration
Dell(conf)#interface vlan 10
Dell(conf-if-vl-10)#mode remote-port-mirroring
Dell(conf-if-vl-10)#tagged te 0/4
Dell(conf-if-vl-10)#exit
Dell(conf)#monitor session 1 type rpm
Dell(conf-mon-sess-1)#source te 0/5 destination remote-vlan 10 dir rx
Dell(conf-mon-sess-1)#no disable
Dell(conf-mon-sess-1)#exit
Dell(conf)#inte vlan 100
Dell(conf-if-vl-100)#tagged te 0/7
Dell(conf-if-vl-100)#exit
Dell(conf)#interface vlan 20
Port Monitoring 866