Users Guide

Resetting an Interface to its Factory
Default State
You can reset any configurations applied on an interface to its factory default state. To reset the
configuration, perform the following steps:
1 View the configurations applied on an interface.
INTERFACE mode
show config
Dell(conf)# interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)# show config
!
interface TenGigabitEthernet 1/1
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
Interfaces 893
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
2 Reset an interface to its factory default state.
CONFIGURATION mode
default interface interface-type slot/port[]
Dell(conf)#default interface tengigabitethernet 1/5
3 Verify the configuration.
INTERFACE mode
show config
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
All the applied configurations are removed and the interface is set to the factory default state.
Interfaces 502