Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsC1048P Port Extender
1121112211231124112511261127112811291130
• When booting from the local flash, boot up with an image stored in the same partition: A or B.
A firmware upgrade includes upgrades for the system image, BIOS, and bootcode. Use the upgrade
command to upgrade the switch firmware by downloading an image from a network server or from the local
flash. This image contains independent images for the CPUs: Control Processor (CP), Route Processor (RP),
and line-card processor (LP). Each separate image runs on a different CPU and are unpacked and
downloaded on the appropriate CPU via the party bus. You can use TFTP or FTP to copy images to the local
storage of each CPU.
Upgrade Procedures 1121