Install Guide

30 System and Security Properties
RSA BSAFE Cert-J 6.2.4 Installation Guide
To collect the test results in an HTML report:
1. In the development environment, run the following Gradle task:
pullvariantTestReport
where variant is one of:
–
certj
– certjFips
– certjNative
– certjNativeFips
2. View <root>/certj-src/android/BsafeAndroid/build/reports to
locate the reports for each test.
System and Security Properties
System and security properties in Cert-J are used to statically register the JCE provider
and to configure the toolkit and FIPS-140 mode behavior.
For further detail, see the Welcome to the Cert-J Toolkit -> Introduction To Cert-J
-> System and Security Properties section of the RSA BSAFE Cert-J Developers
Guide.
Uninstallation Instructions
To uninstall Cert-J on all platforms, remove all files and directories created during the
installation process.