Release Notes

Fabric OS v7.0.1 Release Notes v1.0 Page 9 of 67
to 10 DCX8510 chassis per fabric. This license is required to be installed on every DCX8510 chassis with ICLs
in a fabric when an ICL based topology exceeds the four chassis limit. This license is only
recognized/displayed when operating with FOS v7.0.1 and later.
Temporary License Support
The following licenses are available in FOS v7.0.1 as Universal Temporary or regular temporary licenses:
Fabric (E_Port) license
Extended Fabric license
Trunking license
High Performance Extension license
Advanced Performance Monitoring license
Adaptive Networking license
Fabric Watch license
Integrated Routing license
Server Application Optimization license
Advanced Extension license
Advanced FICON Acceleration license
10GbE FCIP/10G Fibre Channel license
FICON Management Server (CUP) license
Enterprise ICL license
Note: Temporary Licenses for features available on a per slot basis enable the feature for any and all slots in
the chassis.
Temporary and Universal Temporary licenses have durations and expiration dates established in the licenses
themselves. FOS will accept up to two temporary licenses and a single Universal license on a unit. Universal
Temporary license keys can only be installed once on a particular switch, but can be applied to as many
switches as desired. Temporary use duration (the length of time the feature will be enabled on a switch) is
provided with the license key. All Universal Temporary license keys have an expiration date upon which the
license can no longer be installed on any unit.
Supported Switches
Fabric OS v7.0.1 supports the Brocade 300, 5410/5424/5450/5460/5470/5480/NC-5480, 5100, 5300,
VA-40FC, Brocade Encryption Switch (BES), DCX/DCX-4S, 8000, 7800, 6505, 6510, DCX8510-8 and
DCX8510-4.
Access Gateway mode is also supported by Fabric OS v7.0.1, and is supported on the following switches: the
Brocade 300, 5100, VA-40FC, 8000, 5450, 5460, 5470, 5480, NC-5480, M5424, 6510, 6505.
Standards Compliance
This software conforms to the Fibre Channel Standards in a manner consistent with accepted
engineering practices and procedures. In certain cases, Brocade might add proprietary supplemental
functions to those specified in the standards. For a list of FC standards conformance, visit the
following Brocade Web site: http://www.brocade.com/sanstandards
The Brocade 8000 and FCOE10-24 blade conform to the following Ethernet standards:
IEEE 802.1D Spanning Tree Protocol