Reference Guide

Fabric OS Command Reference 715
53-1002921-02
portCfgDPort
2
• A set of ports separated by commas, for example "3,5,7,8"or 5/3,5,7,8 on
bladed systems.
• A wildcard '*' indicates all ports. The wild card should be enclosed in single
quotation marks.
--enable
Configures the specified port(s) as D_Port.
You cannot configure the port as a D_Port while Dynamic D_Port tests are in
progress on the port. The operation fails with an error message.
-dwdm
Skips the optical loopback test when you run the D_Port diagnostics over a Dense
Wavelength Division Multiplexing (DWDM) link or any third party equipment that
connects two switches. This operand is optional.
--disable
Clears the D_Port configuration on the specified ports.
-dwdm
Disables DWDM mode on the port. This operand is optional.
--help
Displays the command usage.
EXAMPLES To configure a single port as a D_Port:
switch:admin> portdisable 42
switch:admin> portcfgdport --enable 42
switch:admin> portenable 42
To clear the D_Port configuration:
switch:admin> portdisable 42
switch:admin> portcfgdport --disable 42
switch:admin> portenable 42
SEE ALSO fabricLog, portCfg, portDPortTest, portShow, switchShow