Reference Guide

xxvi Fabric OS Command Reference
53-1002921-02
• portSwap - You cannot run this command if the ports are from a faulty blade.
• portThConfig - Added the SL area option.
• rasMan - The MAPS class indicates that the message is a MAPS audit message.
• secStatsShow - The INVALID_CERT policy name is no longer supported.
• sfpShow - Added command example for a quad small form-factor pluggable (QSFP).
• snmpConfig - Removed the unsupported protocols (3DES, AES192, AES256) from the SNMPv3
configuration command. Added a command example to display the access control
configuration.
• spinFab - This command supports a maximum of 16 E_Port ICL links. You cannot interrupt the
test by pressing the return key (<cr>).
• supportShow - Corrected the command syntax.
• switchShow - This command displays the World Wide Port Name (WWPN) of the remote device
port. The -qsfp option is supported with the -slot operand. Added the following new comments:
D-Port Dynamic, D-Port F-Port WWN Dynamic, SIM-Port, and Disabled (Fabric Vision License
required).
• switchStatusShow - This command will be disabled if MAPS is enabled on the switch.
• thConfig - The -trigger below command is supported with the -sfptype option. Updated the
description of the -area_only operand.
• topologyShow - The “Path Count” field is enhanced to display the total number of active paths
to the destination domain. The maximum number of paths supported is 16.
• traceDump - Added the name format of the trace dump file generated for an AP blade.
Corrected the name format of the default trace dump file.
• tsTimeZone - The option 11 (none) in interactive command mode is not supported.
• turboRamTest - You cannot interrupt the test by pressing the return key (<cr>).
• version - Updated the command example.
• zone - Added the -i operand to the --validate command and the -ic operand to the --show
command to display all zone members and TI zone configurations for a given pattern without
case distinction.
• zoneShow - Added the --ic operand to display all zone configuration names for a given pattern
without case distinction.
Deprecated commands
The following commands and associated man pages have been removed since this document was
last released:
• trackChangesHelp
• trackChangesSet
• trackChangesShow