Users Guide

Using Broadcom Advanced Control Suite 4NetXtreme User Guide
Broadcom
®
April 2019 • 2CS57XX-CDUM515 Page 75
9. Select the probe interval (the number of seconds between each retransmission of a link packet to the probe
target) and the maximum number of probe retries (the number of consecutively missed responses from a
probe target before a failover is triggered).
10. Set the Probe VLAN ID to allow for connectivity with probe targets residing on a tagged VLAN. The number
set must match the VLAN ID of the probe targets as well as the port(s) on the switch to which the team is
connected.
11. Click the probe target at the top of the list, click Edit Target IP Address, type the target IP address in the IP
Address box for one or all probe targets, and then click OK. Click Next.
12. Select a listed team member, click Edit Member IP Address, and then type the member IP address in the
IP Address box. Repeat for all listed team members and then click OK. Click Next.
Note: Each LiveLink enabled team can only communicate with Probe Targets on a single VLAN. Also,
VLAN ID 0 is equivalent to an untagged network. If the Probe VLAN ID is set to a value other than 0,
then a VLAN must be created with an identical VLAN tag value (see Step 16 on page 78).
Note: Only the first probe target is required. You can specify up to three additional probe targets to
serve as backups by assigning IP addresses to the other probe targets.
Note: All of the member IP addresses must be in the same subnet as the subnet of the probe targets.