User guide

NetXtreme II User Guide
September 2013
Broadcom Corporation
Page 250 Managing Ethernet Controller (Port) Document INGSRVT78-CDUM100-R
BACScli -t NDIS -f mac -i 0010181a1b1c "networkdiag -p 192.168.1.5"
2. The following command runs the network test for the current selected virtual adapter. Since there is no IP address
specified, BACScli will use gateway address for the test.
BACScli -t VNIC -f mac -i 0010181a1b1c "networkdiag"
In Interactive mode, use the list <view> and select <idx> commands to select the desired target device. Use
networkdiag [-p <IP address>] to run the network diagnostics test for the selected target.
Examples:
1. The following command runs the network test for the currently selected NDIS adapter.
networkdiag -p 192.168.1.5
2. The following command runs the network test for the current selected virtual adapter.
networkdiag