User guide

NetXtreme II User Guide
September 2013
Broadcom Corporation
Page 210 FCoE Boot from SAN Document INGSRVT78-CDUM100-R
are set to yes and DCB required is set to no.
7. For each interface to be enabled for FCoE boot, click on Create FCoE VLAN Interface. The VLAN interface creation
dialog will launch. Click Yes to confirm. This will trigger automatic FIP VLAN discovery. If successful, the VLAN will be
displayed under FCoE VLAN Interface. If no VLAN is visible, check your connectivity and switch configuration.
8. Once complete with configuration of all interface, click OK to proceed.