User guide

User Guide NetXtreme II
September 2013
Broadcom Corporation
Document INGSRVT78-CDUM100-R FCoE Boot from SAN Page 207
LINUX FCOE BOOT INSTALLATION
Configure the adapter boot parameters and Target Information (press CTRL+S and enter the CCM utility) as detailed in
Preparing System BIOS for FCoE Build and Boot. Then, use the guidelines in the following sections for FCoE boot
installation with the appropriate Linux version.
• SLES11 SP2 Installation
• RHEL6 Installation
SLES11 SP2 Installation
1. Boot from the SLES11 SP2 installation medium and on the installation splash screen press F6 for driver update disk.
Select Yes. In boot options, type withfcoe=1. Select Installation to proceed.
2. Follow the on screen instructions to choose the Driver Update medium and load drivers.