Instruction Manual

October 2007 Page 9 Dell Enterprise Product Group
enabled.ThedisplayedEthernetAddresswillmatchtheMACaddress
obtainedwhileusingIBAUTIL.EXE.

6. ChoosetheAdvancedTab.Inthesettingsframe,chooseEnablePMEand
changethevaluetoEnabled.

7. ClickOK.WindowsNT4.0willpromptforareboot.ChooseYes.

8. Afterthesystem
hasrestarted,iftheNICisnotalreadyconnectedtoaswitch
orhub,connectitandshutthesystemdown.

9. Shutthesystemoff.TheconnectionLEDontheNICandswitchorhubwill
remainonindicatingtheNICismonitoringthenetworkforwakeuppackets
directedtoitsMACaddress.

10. SendawakeupsignaltotheMACaddressoftheWOLenabledNIC,andthe
systemwillboot.

Note:IfthesystembootisinterruptedbeforetheOSandtheNICdriverareloaded,the
systemwillnotbeabletoperformWOL
againuntilthesystemisrebootedmanuallyand
theOSanddriverareallowedtoloadandresettheNIC’sWOLregisters.
