Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
80
NetXtreme-E User Guide User Guide for Dell Platforms
10.2 Legacy BIOS Mode
To configure PXE for legacy BIOS mode:
NOTE: For Legacy BIOS boot mode, only TFTP-based PXE over IPv4 is supported.
1. Set the Boot Protocol to PXE in the MBA Configuration menu.
2. Save and reboot the server.
Comprehensive Configuration Management v218.0.14.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
Allow port to be completely disabled by Host OS or driver command. Linux only
[ĸ:ĺ][Enter][Space]:Toggle Value;[ĹĻ]:Next Entry; [ESC]:Quit
Current Adapter:Primary, Bus=33 Device=00 Func=00, MAC=BC:97:E1:D3:2B:40
MBA Configuraiton Menu
Option ROM : Enabled
Boot Protocol : Preboot Execution Environment (PXE)
Boot Strap Type : Auto
Hide Setup Prompt : Disabled
Setup Key Stroke : Ctrl-S
Banner Message Timeout : 5 Seconds
Pre-boot Wake On LAN : Disabled
VLAN Mode : Disabled
VLAN ID : 1
Boot Retry Count : 0
Permit Total Port Shutdown : Disabled