Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
70
NetXtreme-E User Guide User Guide for Dell Platforms
9.2.6 Exiting CCM
To exit CCM, press ESC. Upon an attempt to exit CCM, if changes to any parameter values are detected, Save is prompted
(see Figure 34).
Figure 35: Exiting CCM
User can choose to Save the configuration and exit CCM or Discard any changes and exit CCM. If Save is selected, the
configuration changes, attempt to Exit CCM prompts a choice to continue the current boot or to reboot the system and apply
any pending changes.
Comprehensive Configuration Management v216.0.26.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
Exit Configuration
Exit and Save Configurations
Exit and Discard Configuration
Save Configuration to NVRAM
[Enter]:Enter;[ĹĻ]:Next Entry; [ESC] Quit Menu