Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
69
NetXtreme-E User Guide User Guide for Dell Platforms
Figure 34: Partition <n> Configuration
Bandwidth Reservation – This setting configures the percentage of total available bandwidth that should be reserved
for this partition. The total Bandwidth Reservation assigned for all active partitions cannot exceed 100. A value of 0 on
all partitions indicates equal division of bandwidth between all partitions. This setting is available only on adapters that
support the Bandwidth Reservation feature. This is a numeric setting. The value must be specified in the range 0 to
100.
Bandwidth Limit – This setting configures the maximum percentage of available bandwidth this partition is allowed.
This is a numeric setting. The value must be specified in the range 0 to 100.
Bandwidth Reservation Valid – This setting configures whether BW Reservation is applicable on the current partition.
When this setting is disabled, the BW Reservation value for the current partition will be ignored. This setting is available
only on adapters that support the Bandwidth Reservation feature.
– Enabled – Turn on BW Reservation
– Disabled – Turn off BW Reservation
Bandwidth Limit Valid – This setting configures whether BW Limit is applicable on the current partition. When this
setting is disabled, the BW Limit value for the current partition will be ignored.
– Enabled – Turn on BW Limit
– Disabled – Turn off BW Limit
RDMA Support – This setting configures the RoCE support for the current partition. This setting is available only when
RDMA is supported on the current partition. This setting will be displayed on the Device Configuration menu in SF mode
and in the NIC Partition Configuration menu in NPar mode.
– Enabled – Turn on RDMA
– Disabled – Turn off RDMA
Comprehensive Configuration Management v214.0.221.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
PF# 0
Bandwidth Reservation : 10
Bandwith Limit : 60
Bandwith Reservation Valid : False
Bandwith Limit Valid : False
RDMA Support : Disabled
Configure bandwith Reservation in Percentage (All Partition Sum <= 100)(0..100)
[Enter]:Enter New Value;[ĹĻ]:Next Entry; [ESC] Quit Menu
Current Adapter:Primary, Bus=3B Device=00 Func=00, MAC=B0:26:28:CB:12:70