Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
66
NetXtreme-E User Guide User Guide for Dell Platforms
9.2.4 MBA Configuration Menu
Figure 32: MBA Configuration Menu
The MBA configuration menu consists of the following items (see Figure 32):
Option ROM – This setting allows the user to control whether the Broadcom legacy option ROM driver should be
advertised or not.
– Enabled – Load legacy option ROM driver
– Disabled – Do not load legacy option ROM driver
Boot Protocol – This setting configures the type of boot to be performed in legacy mode.
– PXE
– None
Boot Strap Type – This setting configures the bootstrap protocol for legacy PXE boot.
– Auto Detect
– BBS
– Int 18h
– Int 19h
Hide Setup Prompt – This setting controls the visibility of the Broadcom legacy configuration setup menus (CCM). This
setting is available only if legacy configuration menus are supported on the adapter.
– Enabled – Do not display hotkey prompt to load CCM.
– Disabled – Display hotkey prompt to load CCM.
Setup Key Stroke – This setting allows users to select the hotkey combination for invoking the Broadcom legacy
configuration setup menus (CCM). This setting is available only if legacy configuration menus are supported on the
adapter.
– Ctrl-S – Press the CTRL key with the S key to load CCM.
– Ctrl-B – Press the CTRL key with the B key to load CCM.
Comprehensive Configuration Management v218.0.14.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
MBA Configuraiton Menu
Option ROM : Enabled
Boot Protocol : None
Boot Strap Type : Auto
Hide Setup Prompt : Disabled
Setup Key Stroke : Ctrl-S
Banner Message Timeout : 5 Seconds
Pre-boot Wake On LAN : Disabled
VLAN Mode : Disabled
VLAN ID : 1
Boot Retry Count : 3
Permit Total Port Shutdown : Disabled
Allow port to be completely disabled by Host OS or driver command. Linux only
[ĸ:ĺ][Enter][Space]:Toggle Value;[ĹĻ]:Next Entry; [ESC]:Quit
Current Adapter:Primary, Bus=33 Device=00 Func=00, MAC=BC:97:E1:D3:2B:40