Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
61
NetXtreme-E User Guide User Guide for Dell Platforms
9.2.1 Main Menu
Figure 29: CCM Main Menu
The Main menu consists of the following items (see Figure 29):
Firmware Image Menu – This menu presents the various component versions present in the current firmware build.
Device Hardware Configuration – This menu presents adapter specific parameters for configuration.
MBA Configuration – This menu presents PXE boot related parameters for configuration.
NIC Partitioning Configuration – This menu presents NIC partition related parameters for configuration.
Blink LEDs – This setting configures the duration for which the LEDs on the physical network port should blink to assist
with port identification. This is a numeric setting. The value must be specified in the range 0 to 15 seconds.
Comprehensive Configuration Management v216.0.47.0
Copyright (C) 2000-2019 Broadcom Limited
All rights reserved.
Main Menu
Firmware Image Menu
Device Hardware Configuration
MBA Configuration
iSCSI Boot Configuration
NIC Partition Configuration
BLINK LEDs : 0
Listing of firmware image versions
[Enter]:Enter;[ĹĻ]:Next Entry; [ESC] Quit Menu
Current Adapter:Primary, Bus=86 Device=00 Func=00, MAC=B0:26:28:CB:21:40