Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
56
NetXtreme-E User Guide User Guide for Dell Platforms
9.1.4 NIC Configuration
This menu presents legacy boot related parameters for configuration. Depending on the adapter type, some settings may
not be available.
Figure 26: NIC Configuration
The NIC Configuration menu consists of the following items (see Figure 26):
Option ROM – This setting allows the user to control whether the Broadcom legacy option ROM driver should be
advertised or not.
– Enabled – Load legacy option ROM driver
– Disabled – Do not load legacy option ROM driver
Boot Strap Type – This setting configures the bootstrap protocol for legacy PXE boot.
– Auto Detect
– BBS
– Int 18h
– Int 19h
Hide Setup Prompt – This setting controls the visibility of the Broadcom legacy configuration setup menus (CCM). This
setting is available only if legacy configuration menus are supported on the adapter.
– Enabled – Do not display hotkey prompt to load CCM.
– Disabled – Display hotkey prompt to load CCM.