Users Guide
Table Of Contents
- Table of Contents
- 1 Regulatory and Safety Approvals
- 2 Functional Description
- 3 Network Link and Activity Indication
- 4 Features
- 4.1 Software and Hardware Features
- 4.2 Virtualization Features
- 4.3 VXLAN
- 4.4 NVGRE/GRE/IP-in-IP/Geneve
- 4.5 Stateless Offloads
- 4.6 Priority Flow Control
- 4.7 Virtualization Offload
- 4.8 SR-IOV
- 4.9 Network Partitioning (NPAR)
- 4.10 Security
- 4.11 RDMA over Converged Ethernet – RoCE
- 4.12 VMWare Enhanced Networking Stack (ENS)
- 4.13 Supported Combinations
- 4.14 Unsupported Combinations
- 5 Installing the Hardware
- 6 Software Packages and Installation
- 7 Updating the Firmware
- 8 Link Aggregation
- 9 System-Level Configuration
- 10 PXE Boot
- 11 SR-IOV – Configuration and Use Case Examples
- 12 NPAR – Configuration and Use Case Example
- 13 Tunneling Configuration Examples
- 14 RoCE – Configuration and Use Case Examples
- 15 DCBX – Data Center Bridging
- 16 DPDK – Configuration and Use Case Examples
- Revision History
Broadcom NetXtreme-E-UG304-2CS
24
NetXtreme-E User Guide User Guide for Dell Platforms
Figure 17: BCM957416M4160 Network Daughtercard (rNDC) Activity and Link LED Locations
3.7 BCM957412N4120DC
The SFP+ port supports two LEDs to indicate traffic activities and link speed. The LEDs are shown in Figure 17 and
described Table 12. Its locations and form factors conform to the OCP 3.0 Design Specification.
Figure 18: BCM957412N4120DC Network Adapter Activity and Link LED Locations
Table 11: BCM957416M4160 Network Daughtercard (rNDC) Activity and Link LED Locations 10GBASET Port 1 and 2
LED Type Color/Behavior Notes
Activity Off No Activity
Green blinking Traffic Flowing Activity
Link Off No Link
Green Linked at 10 Gb/s
Amber Linked at 1 Gb/s
Port 1 Link LED Port 2 Link LED Port 3 Link LED Port 4 Link LED
Port 1 Activity LED
Port 2 Activity LED Port 3 Activity LED Port 4 Activity LED
Port 1 Link LED Port 2 Link LED
Port 1 Activity LED Port 2 Activity LED