Users Guide

3. Using a Phillips #1 screwdriver, secure the M.2 card to the M.2 card carrier with the screw.
CAUTION: Ensure that the screws are tightened by using a torque of 1.7 in-lb (0.19 N-m).
Figure 7. Install the screw that secures the M.2 card to the M.2 card carrier
4. Slide the bracket on the BOSS-S2 module. Using a Phillips #1 screwdriver, secure the bracket on the BOSS-S2 module with
the screw.
Figure 8. Install the screw of the bracket on the BOSS-S2 module
5. Slide the BOSS-S2 module into the BOSS-S2 module bay until it is firmly seated.
24
Install and remove a BOSS-S2 card