Users Guide

6. Using a Phillips #1 screwdriver, remove the screw that secures the M.2 card to the M.2 card carrier.
Figure 6. Remove the screw that secures the M.2 card to the M.2 card carrier
7. Slide the M.2 card from the M.2 card carrier.
Install the BOSS-S2 module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that came with the system.
1. Follow the safety guidelines listed in the Safety instructions on page 17.
2. Follow the procedure listed in the Before working inside your system on page 17.
NOTE: The below procedure is applicable to 1U systems. For more information on 2U systems, see the system-specific
Installation and Service Manual available at www.dell.com/poweredgemanuals.
Steps
1. Align the M.2 card at an angle with the M.2 card carrier.
2. Insert the M.2 card until it is firmly seated in the M.2 card carrier.
Install and remove a BOSS-S2 card
23