Users Guide

After working inside your system

Steps

1. Replace the system cover.

2. If applicable, install the system into the rack.

For more information, see the Rail Installation Guide relevant to your rail solutions at www.dell.com/poweredgemanuals.

3. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.

Remove the BOSS-S2 module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the system.

1. Follow the safety guidelines listed in the Safety instructions on page 17.

2. Follow the procedure listed in the Before working inside your system on page 17.

NOTE: The below procedure is applicable to 1U systems. For more information on 2U systems, see the system-specific

Installation and Service Manual available at www.dell.com/poweredgemanuals.

Steps

1. Disconnect the BOSS-S2 module power cable and signal cable from the system board.

Install and remove a BOSS-S2 card