Service Manual
Table Of Contents
- Alienware m15 R6 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 R6
- Base cover
- Battery
- Battery cable
- Solid-state drive
- Removing the 2230 solid-state drive in SSD slot one
- Installing the 2230 solid-state drive in SSD slot one
- Removing the 2280 solid-state drive in SSD slot one
- Installing the 2280 solid-state drive in SSD slot one
- Removing the 2230 solid-state drive in SSD slot two
- Installing the 2230 solid-state drive in SSD slot two
- Removing the 2280 solid-state drive in SSD slot two
- Installing the 2280 solid-state drive in SSD slot two
- Procedure to move the screw mount in SSD slot one
- Procedure to move the screw mount in SSD slot two
- Speakers
- I/O board
- Memory module
- Wireless card
- Rear-I/O cover
- Touchpad
- Power-adapter port
- Display assembly
- Keyboard-controller board
- System board
- Heat-sink assembly
- USB board
- Power button
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then
place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when
the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a
component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Screw image
Base cover M2.5x1.7 (captive screw) 4
Base cover M2.5x8.5 (captive screw) 2
Base cover M2.5x5 2
Solid-state drive in SSD Slot one M2x4 2
Solid-state drive in SSD Slot two M2x4 2
I/O board M2x4 1
I/O board M2x2 1
Wireless-card bracket M2x4 1
Display hinges M2.5x5 6
Battery M2x4 4
9