Service Manual
Table Of Contents
- Alienware m15 R4 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 R4
- Base cover
- Battery
- M.2 solid-state drive
- M.2 2230 WWAN/solid-state drive
- Rear-I/O cover
- Display assembly
- Speakers
- Touchpad
- Keyboard-controller board
- Right I/O-board
- System board
- Left I/O-board
- Fan and heat-sink assembly
- Power-adapter port
- Power-button assembly
- Keyboard
- Palmrest
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
Before working inside your computer.
2. Remove the base cover.
3. Remove the rear I/O-cover.
About this task
NOTE: The display assembly is a Hinge-Up Display (HUD) and cannot be further disassembled. If components within the display
assembly must be replaced, the entire display assembly is to be replaced.
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure.
32