Service Manual
Table Of Contents
- Alienware m15 R4 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 R4
- Base cover
- Battery
- M.2 solid-state drive
- M.2 2230 WWAN/solid-state drive
- Rear-I/O cover
- Display assembly
- Speakers
- Touchpad
- Keyboard-controller board
- Right I/O-board
- System board
- Left I/O-board
- Fan and heat-sink assembly
- Power-adapter port
- Power-button assembly
- Keyboard
- Palmrest
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Steps
1. Remove the screw (M2x2.5) that secures the M.2 thermal shield to the M.2 2230 mounting bracket.
2. Remove the M.2 2230 thermal shield from the M.2 2230 solid-state drive.
3. Lift and remove the M.2 2230 solid-state drive from the M.2 card slot on the system board.
4. Remove the screw (M2x2.5) that secures the M.2 2230 mounting bracket to the palm-rest assembly.
5. Remove the M.2 2230 mounting bracket from the palm-rest assembly.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive in the following M.2 card slots:
● M.2 card slot 1
● M.2 card slot 2
21