Service Manual
Table Of Contents
- Alienware m15 R4 Service Manual
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Alienware m15 R4
- Base cover
- Battery
- M.2 solid-state drive
- M.2 2230 WWAN/solid-state drive
- Rear-I/O cover
- Display assembly
- Speakers
- Touchpad
- Keyboard-controller board
- Right I/O-board
- System board
- Left I/O-board
- Fan and heat-sink assembly
- Power-adapter port
- Power-button assembly
- Keyboard
- Palmrest
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Steps
1. Ensure that the battery cable has been disconnected from the system board.
2. Remove the four screws (M2x4) that secure the battery to the palm-rest assembly.
3. Remove the four screws (M2x3) that secure the battery to the palm-rest assembly.
4. Remove the battery from the palm-rest assembly.
Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
18