Reference Guide
Table Of Contents
- Me and My Dell For Inspiron, G-Series, XPS, and Alienware computers
- Contents
- Setting up your computer
- About your computer
- Using your computer
- Ports and connectors
- Software and Applications
- Restoring your operating system
- Troubleshooting
- BIOS
- Getting help and contacting Dell
- References
The Event Log tab in the Status window displays the errors that occurred during the ePSA tests.
Beep codes
Your computer may emit a series of beeps during start-up if there are errors or problems. This series of beeps, called a beep code,
identifies a problem. If this occurs, note the beep code and contact Dell for assistance.
NOTE: Some of the beep codes mentioned in the table below may not apply to your computer.
Table 12. Beep codes and possible problems
Beep codes Possible problems
One Possible system board failure—BIOS ROM checksum failure.
Two No RAM detected
NOTE: If you installed or replaced the memory module, ensure that the memory module is
seated properly.
Three Possible system board failure—Chipset error
Four RAM read/write failure
Five Real‑time Clock failure
Six Video card or video controller failure
Seven Processor failure
NOTE: This beep code is supported for computers with Intel processor only.
Eight Display failure
50