Service Manual

Steps

1. Place the keyboard on the palm-rest assembly.

2. Replace the 33 (M1.2x1.6) screws that secure the keyboard to the palm-rest assembly.

3. Place the keyboard bracket on the keyboard.

4. Replace the nine (M1.2x2.1) screws that secure the keyboard bracket to the keyboard.

5. Connect the keyboard cable to the keyboard-controller board and close the latch.

6. Connect the keyboard-backlight cable to the keyboard controller board.

7. Replace the two (M2x1.9) screws that secure the keyboard-backlight cable to the keyboard-controller board.

Next steps

1. Install the

power-button assembly.

2. Install the system board.

3. Install the right I/O-board.

4. Install the left I/O-board.

5. Install the battery.

6. Install the rear I/O-cover.

7. Install the 2230 solid-state drive. (if applicable)

8. Install the 2280 solid-state drive. (if applicable)

9. Install the base cover.

10.Follow the procedure in

After working inside your computer.