Service Manual

Steps

1. Place the power-button assembly and its cable in the slot on the palm-rest assembly.

2. Place the power-button bracket on the power-button assembly.

3. Replace the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly.

4. Adhere the power-button assembly cable on the palm-rest assembly.

Next steps

1. Install the

system board.

2. Install the right I/O-board.

3. Install the left I/O-board.

4. Install the

battery.

5. Install the rear I/O-cover.

6. Install the 2230 solid-state drive. (if applicable)

7. Install the 2280 solid-state drive. (if applicable)

8. Install the

base cover.

9. Follow the procedure in After working inside your computer.

Keyboard

Removing the keyboard

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the 2230 solid-state drive. (if applicable)

4. Remove the 2280 solid-state drive. (if applicable)

5. Remove the rear I/O-cover.

6. Remove the battery.

7. Remove the left I/O-board.

8. Remove the right I/O-board.

9. Remove the

system board.