Service Manual

Installing the power-adapter port

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the power-adapter port and provides a visual representation of the installation

procedure.

Steps

1. Place the power-adapter port into the slot on the palm-rest assembly.

2. Place the power-adapter port bracket on the power-adapter port.

3. Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.

Next steps

1. Install the system board.

2. Install the right I/O-board.

3. Install the battery.

4. Install the

rear I/O-cover.

5. Install the 2230 solid-state drive. (if applicable)

6. Install the 2280 solid-state drive. (if applicable)

7. Install the base cover.

8. Follow the procedure in After working inside your computer.

Power-button assembly

Removing the power-button assembly

Prerequisites

1. Follow the procedure in Before working inside your computer.