Service Manual

Steps

1. Disconnect all the cables connected to the system board.

NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the

system board. For information on system-board connectors, see "system-board components".

2. Remove the eight screws (#6-32) that secure the system-board assembly to the chassis.

3. Lift the system board off the chassis.

Installing the system board

Prerequisites

Ha valamelyik alkatrész cseréjére van szükség, távolítsa el az eredetileg beszerelt alkatrészt, és ezt követően végezze el a beszerelési

eljárást.

About this task

The following images indicate the location of the system board and provides a visual representation of the installation procedure.