Service Manual

Steps

1. Disconnect the tron-light cable and then remove the cable from the routing guides on the chassis.

2. Lay the computer on the right side.

3. Slide the power-supply unit cage release latches to the unlock position.

4. Lift the power-supply unit cage and rotate the power-supply unit cage away from the chassis.

5. Disconnect the USB cables, LED controller cable and audio cable from the system board and remove the cables from the routing

guides on the inside of the chassis.

6. Place the computer in an upright position.

7. Rotate the power-supply unit cage towards the chassis.

8. Rotate and pull the front bezel away from the front of the chassis to release the tabs on the front bezel from the slots on the front

panel.

9. Remove the two screws (#6-32) that secure the front-panel slot cover to the chassis.

10.Remove the cable management cover off the chassis.

11. Route the cables through the slot on the front panel and lift the front bezel away from the chassis.

Installing the front bezel

Prerequisites

Ha valamelyik alkatrész cseréjére van szükség, távolítsa el az eredetileg beszerelt alkatrészt, és ezt követően végezze el a beszerelési

eljárást.