Service Manual
Table Of Contents
- Alienware Aurora R9 Service Manual
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Left-side cover
- Top cover
- Right-side cover
- 2.5-inch hard drive
- 3.5-inch hard drive
- 2.5-inch hard-drive cage
- 3.5-inch hard-drive cage
- 460 W power-supply unit
- 850 W Power-supply unit
- Right tron-light board
- Processor liquid-cooling assembly
- Coin-cell battery
- Memory modules
- Solid-state drive
- Single-graphics card
- Dual-graphics card
- Front bezel
- Top bezel
- Bottom cover
- Processor fan and heat-sink assembly
- Processor
- Wireless card
- Antennas
- Front I/O-panel
- Front-chassis fan
- Top-chassis fan
- Power-button board
- System board
- Device drivers
- System setup
- Troubleshooting
Steps
1. Disconnect the data and power cables from the hard drive.
2. Press the release tabs on the hard-drive carrier and slide the hard-drive assembly out of the hard-drive cage.
3. Pry the hard-drive carrier to release the tabs on the assembly from the slots on the hard drive.
4. Lift the hard drive out of the hard-drive assembly.
NOTE: Note the orientation of the hard drive so that you can replace it correctly.
NOTE: Repeat the steps to remove any additional 2.5-inch hard drive from your computer.
Installing the 2.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the 2.5-inch hard drive and provides a visual representation of the installation
procedure.
19