Service Manual

Removing and installing components

Recommended tools

The procedures in this document may require the following tools:

• Phillips screwdriver #1

• Phillips screwdriver #0

• Plastic scribe

Screw list

NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and

then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is

restored when the component is replaced.

NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when

replacing a component.

NOTE: Screw color may vary with the configuration ordered.

Table 1. Screw list

Component Secured to Screw type Quantity Screw image

Audio daughter-board Palm-rest assembly M2.5x2.5 3

Battery Palm-rest assembly M2.5x5 6

Computer base Palm-rest assembly M2.5x12 1

Computer base Palm-rest assembly M2.5x8 14

Display-cable bracket System board M2x3 1

Display assembly Computer base M2.5x8 2

Display assembly Palm-rest assembly M2.5x2.5 4

Graphics card System board M2x3 3

Graphics-card cable Graphics card M2x3 2

Graphics-card cable System board M2x3 2