Service Manual

5. Install the display assembly.
6. Install the rear-I/O cover.
7. Install the solid-state drive interposer board, if applicable.
8. Install the solid-state drive in M.2 slot four, if applicable.
9. Install the
solid-state drive in M.2 slot three, if applicable.
10.Follow the procedure from step 5 to step 8 in Installing the hard drive, if applicable.
11. Install the solid-state drive in M.2 slot two.
12. Install the
solid-state drive in M.2 slot one.
13. Install the wireless card.
14. Install the memory modules.
15.Install the battery.
16.Install the base cover.
17. Follow the procedure in After working inside your computer.
Palm-rest assembly
Removing the palm-rest assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the
memory modules.
5. Remove the wireless card.
6. Remove the solid-state drive from M.2 slot one.
7. Remove the solid-state drive from M.2 slot two.
8. Follow the procedure from step 1 to step 4 in
Removing the hard drive, if applicable.
9. Remove the solid-state drive from M.2 slot three, if applicable.
10.Remove the solid-state drive from M.2 slot four, if applicable.
11. Remove the solid-state drive interposer board, if applicable.
12. Remove the card-reader board.
13. Remove the
audio daughter-board.
14. Remove the speakers.
15.Remove the coin-cell battery.
16.Remove the touchpad.
17. Remove the
rear-I/O cover.
18.Remove the display assembly.
19.Remove the computer base.
20.Remove the heat-sink assembly.
21. Remove the left power-adapter port.
22.Remove the
system board.
23.Remove the right power-adapter port.
24.Remove the keyboard.
About this task
The following image indicates the location of the palm-rest assembly and provides a visual representation of the removal procedure.
76