Service Manual

Connect the right power-adapter port cable to the connector at the bottom of the system board.

Next steps

1. Install the system board.

2. Install the left power-adapter port.

3. Install the heat-sink assembly.

4. Install the

computer base.

5. Install the rear-I/O cover.

6. Install the solid-state drive interposer board, if applicable.

7. Install the solid-state drive in M.2 slot four, if applicable.

8. Install the solid-state drive in M.2 slot three, if applicable.

9. Follow the procedure from step 5 to step 8 in

Installing the hard drive, if applicable.

10.Install the solid-state drive in M.2 slot two.

11. Install the solid-state drive in M.2 slot one.

12. Install the wireless card.

13. Install the

memory modules.

14. Install the battery.

15.Install the base cover.

16.Follow the procedure in After working inside your computer.

Keyboard

Removing the keyboard

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.

4. Remove the memory modules.

5. Remove the wireless card.

6. Remove the

solid-state drive from M.2 slot one.

7. Remove the solid-state drive from M.2 slot two.