Service Manual

About this task

The following image indicates the location of the graphics card and provides a visual representation of the installation procedure.

Steps

1. Place the graphics card on the system board and align the screw holes on the graphics card with the screw holes on the system

board.

2. Replace the three screws (M2x3) that secure the graphics card to the system board.

3. Replace the two screws (M2x3) that secure the two graphics-card cables to the graphics card.

4. Connect the graphics-card power cable to the graphics card.

Next steps

1. Install the

heat-sink assembly.

2. Install the computer base.

3. Install the rear-I/O cover.

4. Install the solid-state drive from M.2 slot four, if applicable.

5. Install the

solid-state drive from M.2 slot three, if applicable.

6. Follow the procedure from step 5 to step 8 in Installing the hard drive, if applicable.

7. Install the solid-state drive in M.2 slot one.

8. Install the wireless card.

9. Install the memory modules.

10.Install the

battery.

11. Install the base cover.

12. Follow the procedure in After working inside your computer.

Left power-adapter port

Removing the left power-adapter port

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.