Service Manual

6. Install the solid-state drive in M.2 slot three, if applicable.

7. Follow the procedure from step 5 to step 8 in Installing the hard drive, if applicable.

8. Install the solid-state drive in M.2 slot two.

9. Install the solid-state drive in M.2 slot one.

10.Install the

battery.

11. Install the base cover.

12. Follow the procedure in After working inside your computer.

Display assembly

Removing the display assembly

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the wireless card.

4. Remove the rear-I/O cover.

About this task

The following image indicates the location of the display assembly and provides a visual representation of the removal procedure.