Service Manual

Steps

1. Place the card-reader board in the slot on the palm-rest assembly.

2. Align the screw holes on the card-reader board with the screws holes on the palm-rest assembly.

3. Replace the three screws (M2.5x2.5) that secure the card-reader board to the palm-rest assembly.

4. Route the card-reader board cable through the routing guides on the computer base.

5. Connect the card-reader board cable to the system board.

Next steps

1. Install the

computer base.

2. Install the rear-I/O cover.

3. Install the

solid-state drive in M.2 slot two.

4. Install the wireless card.

5. Install the battery.

6. Install the base cover.

7. Follow the procedure in After working inside your computer.

Coin-cell battery

Removing the coin-cell battery

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.

4. Remove the

solid-state drive from M.2 slot two.

5. Remove the card-reader board.

About this task

The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.