Service Manual

Next steps

1. Install the base cover.

2. Follow the procedure in After working inside your computer.

Rear-I/O cover

Removing the rear-I/O cover

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

About this task

The following image indicates the location of the rear-I/O cover and provides a visual representation of the removal procedure.

Steps

1. Remove the two screws (M2.5x7) that secure the rear-I/O cover to the palm-rest assembly.

2. Disconnect the tron-light cable from the system board and peel it off from the computer base.