Service Manual

Removing the front-bezel heat sensor cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot.
2 Remove the left and right side-panels. See “Removing the side panels”.
3 Remove the PCI fan.
Procedure
1 Disconnect the front-bezel heat sensor cable from the system board.
2 Remove the front-bezel heat sensor cable from the routing guides on the chassis.
3 Remove the two screws (M3x5.25) that secure the PCI fan holder to the chassis.
4 Slide and remove the PCI fan holder from the chassis.
80