Service Manual

Removing the logo board
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot.
2 Remove the left and right side-panels. See “Removing the side panels”.
3 Remove the top fan.
Procedure
NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the
logo board.
1 Disconnect all the cables from the logo board.
2 Remove the screw (#6-32x6) that secures the logo board to the chassis.
72