Service Manual

Removing the antenna cables
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot.
2 Remove the left and right side-panels. See “Removing the side panels”.
3 Remove the handle bars.
4 Remove the graphics card.
5 Remove the wireless card.
6 Remove the front bezel.
7 Remove the rear bezel.
Procedure
1 Lay the chassis on the right side.
2 Disconnect the antenna cables from the wireless card.
3 Remove the antenna cables from the routing guide on the chassis.
4 Slide the antenna cables through the slot on the chassis.
5 Turn the chassis over.
6 Remove the antenna cables from the routing guide on the chassis.
127