Service Manual

Removing the rear bezel
WARNING: Before working inside your computer, read the safety information that shipped with your computer and
follow the steps in Before working inside your computer. After working inside your computer, follow the instructions
in
After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the stability foot.
2 Remove the left and right side-panels. See “Removing the side panels”.
3 Follow the procedure from step 1 to step 3 in Removing the handle bars to remove the rear handle bar.
Procedure
1 Disconnect the rear I/O accessibility lighting cable from the I/O board.
2 Open the securing clip which secures the rear I/O accessibility lighting cable to the chassis.
3 Remove the rear I/O accessibility lighting cable through the routing guides on the chassis.
4 Remove the rear I/O accessibility lighting cable through the slot on the chassis.
112