Service Manual

3. Remove the left and right side-panels. See “Removing the side panels”.
4. Locate the CMOS jumper (RTC_CLR1) on the system board. See “system-board components”.
5. Remove the jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
6. Wait for approximately five seconds to clear the CMOS setting.
7. Remove the jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
1. pin 1 2. pin 2
3. pin 3 4. jumper plug
8. Replace the left and right side panels. See "Replacing the side panels”.
9. Replace the stability foot.
125