Service Manual

Removing the Multiple Graphics Cards
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After
Working Inside Your Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
1. Remove the
stability foot.
2. Remove both the left and right side-panels. See “Removing the Side Panels”.
Procedure
1. Lay the chassis on the left side.
2. Locate the graphics cards (PCI-Express x16 card) on the system board. For more information on the graphics card connector, see
“System Board Components”.
3. Remove the graphics bridge that connects the graphics cards.
a. graphics bridge
4. Starting with the graphics card on the PCI-Express x16 card SLOT1, press and push the screw covers covering the screws that
secure the graphics card.
5. Remove the screws that secure the graphics card to the chassis.
6. Press the releasing clips on the power-cable connectors to disconnect the power cables from the graphics card.
NOTE: The location of the power supply connector varies depending on the video card installed.
49