Service Manual

Removing the Memory Module(s)
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After
Working Inside Your Computer. For more safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
1. Remove the
stability foot.
2. Remove both the left and right side-panels. See “Removing the Side Panels”.
Procedure
1. Lay the computer on the left side.
2. Locate the memory modules on the system board. For more information on the memory modules see “System-Board
Components”.
3. Push the securing clips away from the memory module.
4. Grasp the memory module near the securing clip, and then gently ease the memory module out of the memory-module slot.
NOTE: Repeat step 2 to step 3 to remove any other memory modules installed in your computer.
a. securing clips (2)
b. memory module
c. memory-module slot
44