Service Manual

Replacing the power-button board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Use the alignment posts on power-button board bracket to align the power-button
board into the slot on the power-button board bracket.
2 Snap the power-button board in place on the power-button board bracket.
3 Route the power-button board cable through the cable-routing hole on the chassis.
4 Align and snap the power-button module into the slot on the front panel.
5 Connect the power-button board cable to the system board (RIMCON).
6 Turn the chassis over.
7 Route the antenna cable through the routing guides on the power-button board
module.
Post-requisites
1 Replace the top cover.
2 Replace the base cover.
36