Service Manual

6 Replace the screw (M2.5x5) that secures the USB Type-C port bracket to the

system board.

7 Slide the I/O-board cable into the connector on the I/O-board and close the

latch to secure the cable.

8 Adhere the tape that secures the I/O-board cable to the I/O board.

9 Slide the touchpad cable into the connector on the system board and close

the latch to secure the cable.

10 Insert the RGB per key keyboard cable (optional) into the connector and

press down the latch to secure the cable.

11 Connect the speaker cable to the system board.

12 Connect the power-adapter port cable to the system board.

13 Route the coin-cell battery through the routing channel and adhere the tape

to secure the cable.